[Jatinder Mann]

Hi Lim Phang Moh,

For me it worked best with the LoRaWAN 1.0.3. When using the 1.0.2, I kept getting the error OP TX not sending and unknown error. I’ll keep continue testing, and update further. Also thank you for your quick reply.

Thanks,

Jatinder Mann

[Jatinder Mann]

Hi Lim Phang Moh,

My sensor (https://media.digikey.com/pdf/Data%20Sheets/Adafruit%20PDFs/4007_Web.pdf) has a quiescent current of about 2.2 mA.

What kind of capacitor do you recommend using? Also would it be necessary to add a resistor when using the capacitor?

Thanks,

Jatinder Mann

[Jatinder Mann]

Hello, Lim Phang and Stephane!

Just wanted to give you an update on replacing the u.FL connector.

For me the best way was to use the heat gun, I bought a heat gun online and it took me less than 5 minutes to get the u.FL connector off properly.

I did try the soldering iron, but my skills were not that good. So I would advise anyone reading this, that if you try to replace the u.FL connector with the spring antenna or a wire use a heat gun it is MUCH EASIER especially if you do not have good skill using the soldering iron.

Jatinder Mann

[Jatinder Mann]

Hello, thank you Lim Phang and Stephane!

I appreciate your quick replies and I will I give an update once I have done the job.

Thanks,

[Author]

Posts